D-O Mini Control & Power PCBs

The D-O Mini control and power pcbs are made for Michael Baddeleys D-O V2.

The difference to the other D-O Board is the smaller size, no need for the Arduino Nano and it only works with an iBUS receiver
That means only 1 wire needed from receiver to controller.

They come completely populated with DFPlayer, Terminals, etc.

You only need your own Arduino Mega 2560 for the control sketch – Use the IBUS Sketch from the link below!

For more information, manual & firmware check out the Printed Droid Wiki: https://www.printed-droid.com/kb/d-o-control-and-power-board/
The boards come without the receiver!