Dome Benduino AIO Pro (2024)

The Dome Benduino AIO (2024) is a single PCB with a master and client Benduino and the FLTHY Holo pcb on one pcb – less wiring for you

But instead of soldering all the Arduino components it runs off an ArduinoNano and has its own power for the servos.

It comes pre-built with your desired sketch for the master (which can always be overwritten with another one).

The boards can run Marcduino v2x or the Betterduino firmware

The 2024 Version has Arduino Nanos! Upload Sketch via their ISP header (master/Client) and configure them easily via the USB Ports.

Features:

• small form factor of 101 x 71mm
• fully compatible with the Marcduino firmware
• all (well most) needed pins are available as terminals
• voltage regulators on board or power the servos external

For more information check out the Printed Droid Wiki: https://www.printed-droid.com/kb/benduino-system/

If you want to build your own board select DIY Kit. You’ll get the PCB with smd components pre-soldered. The other components are pretty easy to source.

Original Flthy code rights belong to FlthyMcNasty (Ryan Sondgeroth) and Marcduino V2 software rights belong to CuriousMarc & Neil Hutchinson and Marcduino V3 rights belong to Neil Hutchinson.